We finally have the hood to cowl support assy.  ready to be
glued on. It took quite a bit of fitting to get it right. We first fit
it to the cowl, then made sure the hood fit smoothly to the
frame and glued it in.
You can see where we fabricated pads to
hold the hood latch and pin
assy.                                                  We
hopefully will get the edge of the hood
cleaned up this week, and then
Gel-Coated     
The front end has been coated with gel coat for the
final time. It will now be blocked (sanded) down,Then
the final body work will be done
We've put the front end out to dry in the sun.
Hopefully we'll have it blocked down by the
end of the week
Well the blocking is about 1/2 way done
and some body work has been started
Nov  07